Home » RINNAI Wired Programmable Control Operation Manual Reverse Cycle Air Conditioner

RINNAI Wired Programmable Control Operation Manual Reverse Cycle Air Conditioner

SAFETY PRECAUTIONS

Do not install this product adjacent to areas susceptible to flammable gas leaks. If flammable gases leak near the control, it may cause a fire. Do not operate with wet hands or let water enter the control. Otherwise, an electric shock may occur.
The wiring should be suitably sized for the control current. Incorrectly sized wiring may overheat and cause a fire. The specified cables shall be applied to the wiring. Do not allow external forces to pull on the terminals. Damage to the control and overheating may cause a fire.

INSTALLATION ACCESSORIES

Select the appropriate installation location

Don’t install in an area contaminated with heavy oils, vapors, or gases that may cause the control to deform, this may lead to a system malfunction.

Preparation before installation

Wired programmable control installation precautions.

This manual describes the installation method of the control. Please refer to the
wiring diagram in this installation manual to wire the controller to the indoor unit.

  • This manual describes the installation method of the control. Please refer to the wiring diagram in this installation manual to wire the control to the indoor unit.
  • The wired control works in a low voltage loop circuit. Do not connect the control
    directly to mains voltage (240V), or to three phase power (415V) as it will damage
    the control. Ensure that the control wiring (low voltage loop) and any mains cables
    are adequately separated.
  • A 6 metre wired control wiring loom is provided with plugs with the wired control.
  • The wired control wiring between the control and the indoor unit can be made
    longer than the 6 metres provided, but cannot be more than 20 metres in length.
  • The shielded communication wiring loom must be properly grounded.

INSTALLATION METHOD

Wired remote controller dimensions

Installation diagram

  • Connect the female wiring connector from the indoor unit mainboard
    with the male connector of the interconnecting wiring loom.
  • Connect the other end of the interconnecting wiring loom to the male
    wiring connector from the wired control.
  • Remove upper part of wire controller. Insert a slot screwdriver into the slots in the lower part of the wired controller (2 places), and remove the upper part of the wired controller.

Install the battery in the rear of the control, and make sure the positive side of the battery is correctly aligned on the positive side of the battery connection.

Optional Control extension mounting box

Fix the bottom cover to the electric cabinet with the slotted head screws. Align the bottom cover so it is level on the wall surface, then reinstall the bottom cover of the wall control.

WIRED PROGRAMMABLE CONTROL WIRING DIAGRAM

Wiring diagram of wired control, showing connection with the indoor unit.

LCD Display Layout

  1. Operating mode indicator
  2. 2 Fan speed indicator
  3. 3 Left-right swing indicator
  4. 4 Vertical swing indicator
  5. 5 Cassette Fascia indicator
  6. 6 Follow me indicator
  7. 7 Temperature C°/F° indicator
  8. Temperature display
  9. 9 Lock indicator
  10. 10 Room temperature indicator
  11. 11 Clock display
  12. 12 On/Off timer
  13. 13 Timer display

BUTTON DESCRIPTION

  1. POWER BUTTON
  2. Mode
  3. Adjustment up and down
  4. Fan Speed
  5. VERTICAL SWING (air direction)
  6. HORIZONTAL SWING (air direction)
  7. FOLLOW ME
  8. Timer
  9. DELAY/DAY OFF
  10. Confirm
  11. Back
  12. Copy
  13. IR REMOTE RECEIVER (where tted)