Mist emerges from indoor unit.
Condensation effect due to cooling process.
Water flowing sound during operation.
Refrigerant flow inside the unit.
The room has a peculiar odour.
his may be due to damp smell emitted by the wall, carpet, furniture or clothing.
Indoor fan stops occasionally during automatic fan speed setting.
This helps to remove the surrounding odour.
Airflow continues even after operation has stopped.
Extraction of remaining heat from the indoor unit (maximum 30 seconds).
Operation is delayed a few minutes after restarting.
The delay is a protection to the unit’s compressor.
Outdoor unit emits water/steam.
Condensation or evaporation occurs on pipes.
TIMER indicator is always on.
The timer setting repeats daily once set.
POWER indicator blinks during HEAT mode with no warm air supply (and flap is closed).
The unit is in defrost mode (and AIR SWING is set to AUTO).
Indoor fan stops occasionally during heating operation.
To avoid unintended cooling effect.
POWER indicator blinks before the unit is switched when the ON timer has been set.
This is a preliminary step in preparation for the operation on.
Cracking sound during operation.
Changes of temperature caused the expansion/contraction of the unit.
Discoloration of some plastic parts.
Discoloration is subject to material types used in plastic parts, accelerated when exposed to heat, sun light, UV light, or environmental factor.
Louder noise at outdoor unit during early operation of i AUTO-X.
The compressor and fan rotate at higher speed to boost cooling performance during initial operation.
Dust may have collected around the front panel, grilles and wall surrounding the unit after extended use.
The dust accumulation is due to air purification effect of negative ions from nanoe-G. Remove the dust regularly with a clean dampened cloth.